ZANKER KDV10020FA User Manual

KDV10020FAUser ManualENDishwasher

Option delay1. Set the programme.2. Press the button to delay the start of the programme. The indicator is on.3. Close the appliance door to start

• Close the water tap.If you open the door before the activation of AUTO OFF, the appliance is automatically deactivated.Hints and tipsGeneralThe foll

Before starting a programmeMake sure that:• The filters are clean and correctly installed.• The cap of the salt container is tight.• The spray arms ar

Internal cleaning• Carefully clean the appliance, including the rubbergasket of the door, with a soft damp cloth.• If you regularly use short duration

Problem and alarm code Possible cause and solutionThe program lasts too long.• If the delayed start option is set, cancel the delay setting orwait for

Problem Possible cause and solutionThe dishes are wet.• For the best drying performance activate the option XtraDry.• The programme does not have a dr

Technical informationDimensions Width / height / depth (mm) 446 / 818 - 898 / 550Electrical connection 1)Voltage (V) 220 - 240Frequency (Hz) 50Water s

17

18

19

ContentsSafety information 2Safety instructions 3EASY START 4Programmes 5Settings 5Before first use 8Daily use8Hints and tips 11Care and cleaning 12Tr

www.electrolux.com/shop156908491-A-492016

• If the supply cord is damaged, it must be replaced by the manufacturer, itsAuthorised Service Centre or similarly qualified persons in order to avoi

Warning! Dangerous voltage.• If the water inlet hose is damaged, immediatelyclose the water tap and disconnect the mains plugfrom the mains socket. Co

ProgrammesProgramme Degree of soilType of loadProgramme phases Consumption values1)Duration(min)Energy(kWh)Water(l) 2)Normal soilCrockery and cut-lery

RESET functionPress and hold simultaneously and until the appliance is in programme selection mode.With this function you can cancel the running p

2. Press to change the setting. Each pressing of the button increases the level number. Afterreaching level 10, the count starts again from level

Before first use1. Make sure that the current level of the watersoftener agrees with the hardness of the watersupply. If not, adjust the level of the

Adding detergent212030ABIf the programme has a prewash phase, put a small quantity of detergent also in compartment B.Adding multi-tablets212030• Adju