ZANKER KEI8440XXK User Manual Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 23
2. Clean the appliance with a moist cloth and some
detergent.
3. At the end rub the appliance dry with a clean
cloth.
Troubleshooting
Problem Possible cause Remedy
You cannot activate the appliance
or operate it.
Activate the appliance again and set
the heat setting in less than 10 sec-
onds.
You touched 2 or more sensor
fields at the same time.
Touch only one sensor field.
There is water or fat stains on the
control panel.
Clean the control panel.
An acoustic signal sounds and the
appliance deactivates.
An acoustic signal sounds when the
appliance is deactivated.
You put something on one or more
sensor fields.
Remove the object from the sensor
fields.
The appliance deactivates. You put something on the sensor
field
.
Remove the object from the sensor
field.
The residual heat indicator does not
come on.
The cooking zone is not hot be-
cause it operated only for a short
time.
If the cooking zone operated suffi-
ciently long to be hot, speak to the
service centre.
The heat setting changes between
two levels.
The Power management is activa-
ted.
Refer to “Power management”.
The sensor fields become hot. The cookware is too large or you
put it too near to the controls.
Put large cookware on the rear
cooking zones if necessary.
comes on.
The Automatic Switch Off oper-
ates.
Deactivate the appliance and acti-
vate it again.
comes on.
The Child Safety Device or the
Lock function operates.
Refer to the chapter “Daily Use”.
comes on.
No cookware is on the cooking
zone.
Put cookware on the cooking zone.
The cookware is incorrect. Use the correct cookware.
The diameter of the bottom of the
cookware is too small for the cook-
ing zone.
Move cookware to a smaller cooking
zone.
and a number come on.
There is an error in the appliance. Disconnect the appliance from the
electrical supply for some time. Dis-
connect the fuse from the electrical
system of the house. Connect it
again. If
comes on again, speak
to the service centre.
24
Page view 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Comments to this Manuals

No comments