ZANKER KRT60W User Manual download pdf (Page 13)

Part 1 - INSTALLATION INSTRUCTIONS

2.4 - Choice of operating mode

a) Evacuation mode

To check that the hood is set up for evacuation, open

the grille panel and make sure that the conversion lever

or the change-over knob on the centrifugal unit is in

the DUCTING position (B). The charcoal filter is not

required. For ducting to the outside, the hood is

supplied with a rear and top outlet. A flange spigot of

100 mm diameter (120 mm in certain models) is usually

fitted on the top outlet and a blanking plug on the rear

outlet. If you choose to duct the hood from the rear of

the casing, you should invert the position of the flange

and of the blanking plug. Pay attention to the safety

regulation 1.1.

b) Internal recirculation mode

To check that the hood is set up for recycling, open

the grille panel and make sure that the conversion lever

or the change-over knob on the centrifugal unit is in

the RECYCLING position (A). The charcoal filter is to

be fitted. To fit the charcoal filter, support the filter with

one hand and turn the thumb screw through the centre

of the charcoal filter. If the filter is of the interlocking

type, turn the filter clockwise. The hood can remain

connected to the outside.

2.5 - Electrical connection and

working test

1 - The safety measures 1.2, 1.3, 1.4 and 1.5

of paragraph 1 are to be strictly observed.

2 - Once the electrical connection has been

completed, check that the worktop

illumination, motor and speeds work

properly.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

No comments

ZANKER KRT60W User Manual Page 13