ZANKER KWF71411WE User Manual download pdf (Page 24)

• close the filter cover;

• insert the mains plug

again.

Cleaning the water inlet filters

Important! If the appliance doesn't fill, it takes a long

time to fill with water, the starting button flashes red or

the display (if available) shows the relevant alarm (see

chapter "What to do if..." for more details), check if the

water inlet filters are blocked .

To clean the water inlet filters:

• Turn off the water tap.

• Unscrew the hose

from the tap.

• Clean the filter in the

hose with a stiff brush.

• Screw the hose back onto the tap. Make sure the

connection is tight.

• Unscrew the hose

from the appliance.

Keep a towel nearby

because some water

may flow.

• Clean the filter in the

valve with a stiff brush

or with the piece of

cloth.

• Screw the hose back to the appliance and make

sure the connection is tight.

• Turn on the water tap.

What to do if…

The appliance does not start or stops during operation.

Certain problems are due to lack of simple mainte-

nance or oversights, which can be solved with the help

of the indications described in the charts, without calling

out an engineer.

During appliance operation it is possible that the red

pilot light of the button 9 flashes, the display shows a

fault code and the buzzer sounds to indicate that the

appliance is not working.

Before contacting your local Service Centre, please

carry out the checks listed below.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

ZANKER KWF71411WE User Manual Page 24