ZANKER KEV6140FBB User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
Troubleshooting
Warning! Refer to Safety chapters.
What to do if...
Problem Possible cause Remedy
You cannot activate or operate the
hob.
The hob is not connected to an
electrical supply or it is connected
incorrectly.
Check if the hob is correctly connec-
ted to the electrical supply. Refer to
the connection diagram.
The fuse is blown. Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Residual heat indicator does not
come on.
The zone is not hot because it op-
erated only for a short time.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
If you cannot find a solution...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
Give the data from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the corner of the
glass surface). Make sure, you operated the hob
correctly. If not the servicing by a service technician or
dealer will not be free of charge, also during the
warranty period. The instructions about the Service
Centre and conditions of guarantee are in the guarantee
booklet.
Installation
Warning! Refer to Safety chapters.
Before the installation
Before you install the hob, write down the information
bellow from the rating plate. The rating plate is on the
bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble the hob
into correct built-in units and work surfaces that align to
the standards.
Connection cable
The hob is supplied with a connection cable.
To replace the damaged mains cable use the
following (or higher) mains cable type: H05V2V2-F T
min 90°C. Speak to your local Service Centre.
16
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comments to this Manuals

No comments