ZANKER KWF71411WE User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
Level the appliance by raising or lowering the feet.
The appliance MUST be level and stable on a flat
hard floor. If necessary, check the setting with a spirit
level. Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and dis-
placement of the appliance during operation.
Repeat the levelling action, if the appliance is not lev-
el and stable.
Water inlet
Caution! This appliance must be connected to a
cold water supply
Before connecting up the appliance to new pipework or
to pipework that has not been used for some time, run
off a reasonable amount of water to flush out any debris
that may have collected
The inlet hose is supplied and can been found inside
the machine drum.
Do not use the hose from your previous appliance to
connect to water supply.
1. Open the porthole and extract the inlet hose.
2. Connect the hose with
the angled connection to
the machine. Do not
place the inlet hose
downwards. Angle the
hose to the left or right
depending on the posi-
tion of your water tap.
45°
35°
3. Set the hose correctly by loosening the ring nut.
After positioning the inlet hose be sure to tighten the
ring nut again to prevent leaks.
4. Connect the hose to a
tap with a 3/4” thread.
The inlet hose must not be lengthened. If it is too short
and you do not wish to move the tap, you will have to
purchase a new, longer hose specially designed for this
type of use.
Water-stop device
The inlet hose is provi-
ded with a water stop de-
vice, which protects
against damage caused
by water leaks in the
hose which could devel-
op due to natural ageing
of the hose.
A
This fault is shown by a red sector in the window
«A». Should this occur, turn the water tap off and re-
fer to your Service Centre to replace the hose.
Water drainage
Firstly form a hook in the end of the drain hose using
the plastic hose guide supplied with the appliance .
The end of the drain hose can be positioned in four
ways:
Hooked over the edge of a sink using the plas-
tic hose guide.
8
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments